Command Reference Guide T1 Interface Configuration Command Set
61200990L1-35E Copyright © 2005 ADTRAN 603

T1 INTERFACE CONFIGURATION COMMAND SET

To activate the T1 Interface Configuration mode, enter the interface t1 command at the Global
Configuration mode prompt. For example:
>enable
#
configure terminal
(config)#
interface t1 1/1
(config-t1 1/1)#
The following comm a nd s are com mo n to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <“text”> on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text> on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
clock source [internal | line | through | throug h <interface id>] on page 604
coding [ami | b8zs] on page 605
fdl [ansi | att | none] on page 606
framing [d4 | esf] on page 607
lbo [long <-22.5, -15, -7.5, 0> | short <0-655>] on page 608
loopback commands begin on page 609
remote-alarm [rai] on page 612
remote-loopback on page 613
show test-pattern on page 614
snmp trap line-status on page 615
snmp trap link-status on page 616
snmp trap threshold-reached on page 617
tdm-group <group number> timeslots <1-24> speed [56 | 64] on page 618
test-pattern [clear | insert | ones | p215 | p220 | p511 | qrss | zeros] on page 619