Command Reference Guide PPP Interface Configuration Command Set
61200990L1-35E Copyright © 2005 ADTRAN 883

PPP INTERFACE CONFIGURATION COMMAND SET

To activate the PPP Interface Configuration mode, enter the interface ppp command at the Global
Configuration mode prompt. For example:
>enable
#
configure terminal
(config)#
interface ppp 1
(config-ppp 1)#
The following comm a nd s are com mo n to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text> on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
access-policy <policyname> on page 885
alias link<“text”> on page 888
bandwidth <value> on page 889
bridge-group commands begin on page 890
crypto map <mapname> on page 896
dial-backup commands begin on page 898
dynamic-dns [dyndns | dyndns-custom | dyndns-static] <hostname> <username>
<password> on page 915
fair-queue <threshold> on page 917
hold-queue <queue size> out on page 918
ip commands begin on page 919
keepalive <seconds> on page 945
lldp receive on page 946
lldp send [management-address l port-description l system-capabilities l system-description l
system-name l and-receive] on page 947