Command Reference Guide T3 Interface Configuration Command Set
61200990L1-35E Copyright © 2005 ADTRAN 620

T3 INTERFACE CONFIGURATION COMMAND SET

To activate the T3 Interface Configuration mode, enter the interface t3 command at the Global
Configuration mode prompt. For example:
>enable
#
configure terminal
(config)#
interface t3 1/1
(config-t3 1/1)#
The following comm a nd s are com mo n to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <“text”> on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text> on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
clock source [local | loop] on page 621
coding [b3zs] on page 622
framing [m13 | cbit] on page 623
line-length [short | long] on page 624
loopback network [line | payload] on page 625
loopback remote [line | payload] on page 626
remote-loopback on page 627
show [bert] on page 628
snmp trap link-status on page 629
test-pattern [clear | insert | ones | p215 | p223 | zeros] on page 630