Allied Telesis AT-CV5000 manual Starting a Remote Management Session, Guide

Chapter 2: Installation

Starting a Remote Management Session

The procedure in this section explains how to start a remote management session using the 10/100Base-TX port on the AT-CV5M01 Management Card on the chassis. You can use a remote management session to configure the chassis operating parameters and view performance and error statistics using the AT-S70 management software.

To manage a chassis remotely, you must first assign an IP address to it.

For information about assigning an IP address to the system, refer to

Chapter 1, “Getting Started,” in the AT-S70 Management Software User’s

Guide.

To start a remote management session, perform the following procedure:

1.Connect a twisted pair cable to the 10/100Base-TX port on the front of the AT-CV5M01 Management Card, as shown in Figure 47.

LK AT FD

CPU RESET

LK	A
T
X
RDY
ML/SML	F

245

Figure 47. Connecting a Twisted Pair Cable to the 10/100Base-TX Port on

the AT-CV5M01 Management Card

Note

The RJ-45 port runs in MDIX mode. Be sure to use the proper cable. The connector and port pinouts are shown in “RJ-45 Twisted Pair Port Pinouts” on page 103.

2.In the Telnet application, specify the IP address of the AT-CV5000 chassis that you want to access.

The software initializes and then the login prompt is displayed.

3.Press <Return> twice.

4.When prompted, enter a username and password.

ˆTo configure the chassis settings, enter “manager” as the username. The default password for manager access is “friend”.

ˆTo just view the settings, enter “operator” as the username. The default password for operator access is “operator”.

70