Allied Telesis AT-CV5000 manual Installing an AT-CM70S Line Card

AT-CV5000 Media Converter Chassis Installation Guide

Installing an AT-CM70S Line Card

The AT-CM70S line card is a double-slot line card that takes up two line card slots in the chassis. Therefore, the process for installing this card differs slightly from the process for installing other Converteon™ line cards.

Warning: Remove all metal jewelry, such as rings and watches, before installing or removing a line card from a powered-on chassis.  E26

Caution Be sure to observe all standard electrostatic discharge (ESD) precautions, such as wearing an antistatic wrist strap, to avoid damaging the device. A line card can be damaged by static electricity.

To install an AT-CM70S line card, perform the following procedure:

1.Remove the AT-CM70S line card from its shipping package and store the package in a safe place.

Note

You must use the original package if you need to return the unit to

Allied Telesis.

2.Remove the AT-CV5PNL1 blank slot covers from two adjacent line card slots.

Keep the blank slot covers in a safe area in case you remove the line card. The blank slot covers are used to keep dust from getting into the chassis and maintains proper airflow, cooling, and ventilation throughout the chassis.

3.Locate the top and bottom alignment guides inside the line card slots, as shown in Figure 24 on page 53.

4.Set the line card’s DIP switches.

For more information on the DIP switch settings, refer to the Converteon™ Media Converter Line Cards Reference Guide.

5.Align the back edge of the line card with the top and bottom alignment guides located inside the slot.

79