Removing a Converteon Line Card | Allied Telesis AT-CV5000 guide

Chapter 3: Working with Line Cards and other Modules

Removing a Converteon™ Line Card

To remove a Converteon™ line card, perform the following procedure:

Caution

Be sure to observe all standard electrostatic discharge (ESD) precautions, such as wearing an antistatic wrist strap, to avoid damaging the device. A line card can be damaged by static electricity.

1.Select the line card in the AT-CV5000 chassis you want to remove.

2.Using a Phillips screwdriver, loosen the captive screws at the top of the installed line card.

3.Locate the line card removal tool, as shown in Figure 48.

1137

Figure 48. Line Card Removal Tool

4.Hook the slot at the end of the removal tool onto the captive screw at the top of the line card, and pull towards you to remove the card from the chassis, as shown in Figure 49.

AT-CM202

LK	AT
LK	AT
T
X
RDY
ML/SML	FD/OAM
	FD/OAM

1138

Allied Telesis AT-CV5000 manual Removing a Converteon Line Card

Models: AT-CV5000

Removing a Converteon™ Line Card

Figure 48. Line Card Removal Tool

4.Hook the slot at the end of the removal tool onto the captive screw at the top of the line card, and pull towards you to remove the card from the chassis, as shown in Figure 49.

Figure 49. Removing a Line Card from an AT-CV5000 Chassis

5.Install an AT-CV5PNL1 blank slot cover in the empty slot, as described in “Installing an AT-CV5PNL1 Blank Slot Cover” on page 90.