Chapter 3: Working with Line Cards and other Modules
Installing an AT-PWR15 DC Power Supply
The AT-CV5000 chassis is shipped with two slots in the rear designated for the power supplies, but without any power supplies installed. You must install at least one power supply in order to power on the chassis.
Caution
The AT-CV5000 Media Converter chassis can contain two power supplies of the same type (AC or DC) or a combination of the two types with the same power ratings. Make sure not to mix power supplies with different power ratings in the same chassis.
For information on the power supply module, refer to the documentation that is shipped with the module.
Note
You can install an additional AT-PWR15 DC power supply while the existing power supply is powered ON.
To install an AT-PWR15 DC power supply, perform the following procedure:
1.Remove the AT-PWR15 DC power supply from its shipping package and store the package in a safe place.
Note
You must use the original package if you need to return the unit to
Allied Telesis.
2.Select the power supply slot in the AT-CV5000 chassis where you want to install the AT-PWR15 DC power supply.
3.Turn the power switch OFF.
4.Remove any slot cover that may be covering that slot.
