American Dynamics ADMPCPU manual Using an IP Address Assigned by the Network Dhcp Server, ADCC1100

4.Switch on the CPU. The LCD screen displays the AD Welcome Screen (Figure 10), followed by the CPU Status screen, two examples of which are shown in Figure 11.

Figure 10. AD welcome screen

Figure 11. CPU status screen

or

ADCC1100:

a.Place the keyboard in Program Mode by clicking the tab in the middle of the lower part of the screen).

Note: To display and enter Program Mode, you must insert a Smartcard that has administrator privileges.

b.Press the Matrix Menus softkey.

c.Enter one of the following number sequences for your MegaPower CPU installation:

○Standalone MPCPU: Enter 100.

○Dual MPCPU: Enter 100 for the selected MegaPower CPU, or enter 101 for the Standby MP CPU.

d.Press the Enter softkey.

ADCC0200/0300:

Using an IP Address Assigned by the Network DHCP Server

To set up the MegaPower CPU to obtain an IP address from a DHCP server, do the following:

1.Connect a keyboard to an RS-232 port on the MegaPower CPU. Ensure the baud rates match for the keyboard and CPU port in use.

2.Use the following instructions to provide the key sequences for each supported keyboard:

AD2088:

a.Place the keyboard in Menu Mode by turning the keyswitch to MENU. The Camera field LED on the keyboard should display P6.

b.Enter one of the following number sequences for your MegaPower CPU installation:

○Standalone MPCPU: Enter 100.

○Dual MPCPU: Enter 100 for the selected MegaPower CPU, or enter 101 for the Standby MP CPU.

c.Press the ENTER key, which is located above the joystick. “ENTER” is stenciled on the front face of the key; the top of the key may be labeled either PRESET or SHOT.

The Camera field LED on the keyboard will only display 7P if the selected CPU is accessed.

Notes: In RS–232 mode, the ADCC0200 keyboard does not have matrix menu access capabilities as indicated by the Access Denied message if the following procedure is attempted.

a.Press and hold the Shift () button and then press the Menu () button.

b.Enter one of the following number sequences for your MegaPower CPU installation:

○Standalone MPCPU: Enter 100.

○Dual MPCPU: Enter 100 for the selected MegaPower CPU, or enter 101 for the Standby MP CPU.

c.Press Enter ().

Note: Whenever scrolling to a different line

item on the LCD screen, you must press twice to select the new item.

Note: To exit Program Mode, press and hold the Shift () button, and then press the Clear () button.

ADTTE:

a.Place the keyboard in Program Mode (indicated by –Pbeing displayed at the far right of the LCD).

b.Press the Menu key. The LCD screen displays P6 - M.

c.Enter one of the following number sequences for your MegaPower CPU installation:

○ Standalone MPCPU: Enter 100

MEGAPOWER CPU ADMINISTRATOR’S GUIDE

8200-0421-03, REV. G

10 of 82