American Dynamics ADMPCPU manual Using a Static IP Address, System Menu screen

Models: ADMPCPU

1 86
Download 86 pages 43.09 Kb
Page 13
Image 13

Dual MPCPU: Enter 100 for the selected MegaPower CPU, or enter 101 for the Standby MP CPU.

d.Press the Ack key located in the lower right corner.

The System Menu appears on the LCD screen (Figure 12).

Note: To exit the LCD Menu Mode, press the Menu key.

Figure 12. System Menu screen

3.Press Enter to choose Addressing. The Address Menu screen appears.

Figure 13. Address Menu screen

4.Press Enter to choose IP Address. The IP Address screen appears.

Figure 14. IP Address screen

5.Scroll down to Set IP Addr and press Enter. The Set IP Address screen appears.

Figure 15. Set IP Address screen

6.Scroll down to DHCP and press Enter. The DHCP Setting screen appears.

Figure 16. DHCP Setting screen

7.Press Enter to choose Enable.

8.Exit from the MegaPower CPU menu system.

Using a Static IP Address

To set up the MegaPower CPU for a static IP address:

1.Connect a keyboard to an RS-232 port on the MegaPower CPU. Ensure the baud rates match for the keyboard and CPU port in use.

2.Use the following instructions to provide the key sequences for each supported keyboard:

AD2088:

a.Place the keyboard in Menu Mode by turning the keyswitch to MENU. The CAMERA LEDs on the keyboard display P6.

b.Enter one of the following number sequences for your MegaPower CPU installation:

Standalone MPCPU: Enter 100.

Dual MPCPU: Enter 100 for the selected MegaPower CPU, or enter 101 for the Standby MP CPU.

c.Press the ENTER key, which is located above the joystick. “ENTER” is stenciled on the front face of the key; the top of the key may be labeled either PRESET or SHOT.

The CAMERA LEDs on the keyboard will only display 7P if the selected CPU is accessed.

ADCC1100:

a.Place the keyboard in Program Mode by pressing its softkey.

Note: To display and enter Program Mode, you must insert a Smartcard that has administrator privileges.

b.Press the Matrix Menus softkey.

c.Enter one of the following number sequences for your MegaPower CPU installation:

Standalone MPCPU: Enter 100.

Dual MPCPU: Enter 100 for the selected MegaPower CPU, or enter 101 for the Standby MP CPU.

d.Press the Enter softkey.

ADCC0200/0300:

Notes: In RS–232 mode, the ADCC0200 keyboard does not have matrix menu access

MEGAPOWER CPU ADMINISTRATOR’S GUIDE

8200-0421-03, REV. G

11 of 82

Page 13
Image 13
American Dynamics ADMPCPU manual Using a Static IP Address, System Menu screen