Connect AC Power and Control Wiring
Before you connect AC power and control wiring, connect utility conductors to the PDU. For instructions, see Certified Electrician’s Instructions included with the PDU
Note documentation.
Only qualified personnel trained by APC may connect the AC power and control wiring.
Electrical
Hazard
Attach AC power and control wiring to the UPS. The power wires are coiled in the bottom of the PDU. There are five main input wires, four bypass input wires, and four output wires coiled on the floor of the PDU. Each set of wires is labeled. The control wires for the UPS Maintenance Bypass control board and the UPS EPO control board are also coiled in the PDU. The diagram below provides an overview of the connections that you will make between the PDU and the UPS.
PDU
Maintenance Bypass Control |
EPO Control |
Output |
Bypass |
Input |
UPS |
To make the connections you will need to remove the rear lower panel of the UPS and the rear panel of the PDU. Use the opening in the side panels of the enclosures to run the wires.
26 | InfraStruXure |
