Avaya 1.3 manual Basic Switch Requirements, Connectivity Switch to Avaya CT Server

Pre-Release 11 Link Administration Instructions

DEFINITY ONE Pre-Administration

— Setting Up Your Avaya CT Configuration

Use this section to ensure that you know the requirements of your configuration before you administer DEFINITY ONE for Avaya CT.

Basic Switch Requirements

These are the basic switch requirements.

●The CTI interface requires DEFINITY ONE R2, or later.

●The ASAI Proprietary Adjunct Link option must be enabled on the switch (system- parameters customer-options screen).

Connectivity — Switch to Avaya CT Server

The DEFINITY ONE must be connected to the LAN that the DEFINITY G3 PBX Driver will be using. Keep in mind that there are two basic configurations, which are described in the next two sections.

Configuration Option 1: PROCR/DLG

If you do not require a separate, secure LAN segment for communications to DEFINITY ONE and the telephony server, connectivity is established via the TN795 processor card (PROCR) and the telephony server. In this arrangement, you will need only one NIC.

Configuration Option 2: PROCR/DLG, C-LAN and Data Module

If you require a separate, secure LAN connection from the G3PBX Driver to the DEFINITY ONE, the telephony server will require its own separate LAN card. This means that you will need two Network Interface Cards (NICs) in the Telephony Server, one for client access and one for the connection between the DEFINITY ONE and the DEFINITY G3 PBX Driver. Connectivity is established to DEFINITY ONE via the Control LAN (C-LAN) board (TN799) and a Data Module.

238 Installation Guide