Baldor MN1274 06/2001 installation manual Data Defaulting to

Problem	Check
The message Lost User	If this message is followed by You must now re-tune your
Data: Defaulting to	motor retune the MintDrive by either re-entering the gain settings
Factory settings -	set earlier or by following the tuning setup (see section 4.2 on
please wait... is shown at	page 51).
power-up.	If this message is followed by Failed to automatically
	reset Factory settings. power-cycle the MintDrive.
	If the same message re-appears or the Ready LED stays red,
	contact Baldor Technical Support. Otherwise, retune the MintDrive
	by either re-entering the gain settings set earlier or by following the
	tuning setup (see section 4.2 on page 51).
	If this message is followed by Factory settings have been
	reset, but failed to clear error flag. Try
	clearing the error manually using CANCEL. type
	CANCEL. and power-cycle the MintDrive. If the same message
	re-appears or the Ready LED stays red, contact Baldor Technical
	Support. Otherwise, retune the MintDrive by either re-entering the
	gain settings set earlier or by following the tuning setup
	(see section 4.2 on page 51).
The message	Contact Baldor Technical Support.
Initialization Error is
shown at power-up.
The message Fatal	Contact Baldor Technical Support.
Initialization Error is
shown at power-up.
The message Processor	If new firmware has just been downloaded this message may be
Reset Code = xx is shown at	ignored.
power-up.	If the MintDrive has been power-cycled, power-cycle the MintDrive
	again. If the problem persists contact Baldor Technical Support.
	If the firmware just reset without the unit being power-cycled,
	contact Baldor Technical Support.

88