1
CONTENTS
7. | Make a cut of about 25/32" (2.0 cm) long in |
|
| the fabric. | SETTING |
| 1 25/32" (2.0 cm) | |
|
| |
8. | Raise the presser foot lever, and then thread | UP |
| the bobbin thread and the upper thread. | |
|
| |
|
| SEWING |
| 5 |
| 1 3 |
2 | B |
A | |
| 5 |
1 |
9.Position the fabric so that the right side of the cut goes over the guide plate and the left side of the cut is under the presser foot.
1 Guide plate (lower knife)
2 Presser foot
10.Thread the needle, pull out a long section of the upper thread, pass it under the presser foot, and then pull it out toward the rear of the sewing machine. (See figure B.)
2 Presser foot
3 Upper thread
11.Lower the presser foot lever.
CAUTION
After the stitch width is adjusted, turn the balance wheel toward you by hand and check that the needle does not touch the side cutter. If the needle hits the side cutter and breaks, injuries may occur.
When sewing straight stitches, the seam margin will be about 13/64" (5.0 mm).
1Seam margin
Note
–The side cutter will not cut the fabric if the fabric is simply spread out under the presser foot and the guide plate. Be sure to position the fabric as explained in step 9 before sewing.
–Always raise the needle before raising the presser foot lever.
–Clean the side cutter after using it, otherwise dust and scraps of thread will build up in it.
–Add a small amount of oil as required to the cutting edge of the cutter.
STITCHES | UTILITY |
|
STITCH DESIGNS) | (CREATE YOUR OWN | MY CUSTOM STITCHTM |
EMBROIDERING |
|
|
MAINTENANCE |
|
|
MESSAGES | ERROR |
|
SEWING CHART |
|
|
IN MACHINE) | (PROGRAMMED | PATTERNS |
17
