Brother PC 6500 operation manual Embroidering, Setup, Installing embroidery foot Q, Chapter

EMBROIDERING

SETUP

CHAPTER 5

CONTENTS

Installing embroidery foot Q

CAUTION

Be sure to turn off the power before attaching embroidery foot Q. If the power is left on and the start/stop button is accidentally pressed, the machine will start operating, which could result in serious injury.

1. Press the needle position button to raise the needle, and then turn off the sewing machine.

2. Raise the presser foot lever.

3. With the enclosed screwdriver or disc-shaped screwdriver, loosen the screw on the presser foot holder, and then pull the holder downward to remove it.

1Presser foot holder

4. Slide the bracket on embroidery foot Q up onto the presser foot bar, and then fasten it by firmly tightening the screw with the enclosed screwdriver or disc-shaped screwdriver.

1Embroidery foot Q

CAUTION

Be careful not to touch the tip of the needle, otherwise injuries may occur.

Note

–Make sure that embroidery foot Q is tightly attached to the presser foot bar.

–It is recommended that a 90/14-size needle be used when embroidering thicker fabrics such as denim or when using stabilizing products such as puffy foam. A 75/11-size needle might bend or break, which could result in injuries.

SETTING UP
SEWING
STITCHES	UTILITY
STITCH DESIGNS)	(CREATE YOUR OWN	STITCHTM	MY CUSTOM
EMBROIDERING
MAINTENANCE
MESSAGES	ERROR
SEWING CHART
IN MACHINE)	(PROGRAMMED	PATTERNS

86