Brother PC 6500 operation manual Installing the embroidery unit, Initializing the embroidery unit

Installing the embroidery unit

CAUTION

–Always turn off the main power switch before connecting or removing the embroidery unit.

–Do not touch the connector on the embroidery unit.

–The foot controller cannot be used when the embroidery unit is operational.

–When the embroidery unit is not being used, always store it in its box and packing materials.

–Do not carry the machine with the embroidery unit connected.

–Always set your machine on a flat, level surface.

CONTENTSSETTING UP

1

1.Turn off the sewing machine.

2.Open the connecting slot by sliding the cover in the direction indicated by the arrow.

1 Connecting slot cover

Note

When the embroidery unit is not being used, keep the connecting slot cover closed.

SEWING
STITCHES	UTILITY

3. Insert the connector on the embroidery unit firmly into the connecting slot.

Note

With the sewing machine on a flat, level surface, slide the embroidery unit towards the machine.

Initializing the embroidery unit

1.Turn on the sewing machine. The message shown at the left appears on the screen.

Note

If the buttonhole lever, the needle or the presser foot lever are lowered or if the bobbin winding shaft is moved to the right, an error message appears indicating the current error condition. After the error condition is corrected, the message shown at the left appears.

STITCH DESIGNS)	(CREATE YOUR OWN	MY CUSTOM STITCHTM
EMBROIDERING
MAINTENANCE
MESSAGES	ERROR

2.Press . The embroidery arm moves to its initial position.

CAUTION

–Do not place your hands near the embroidery arm, otherwise injuries may occur.

–Please note that the embroidery arm normally makes noises while it moves to its initial position.

–If the embroidery unit could not be initialized normally, a buzzer will sound. If this occurs, make sure that a embroidery frame is not attached and try initializing the embroidery unit again.

SEWING CHART
IN MACHINE)	PATTERNS (PROGRAMMED

87