Chapter 5: Local Management
5.15.2 Changing Source and Destination Ports
Add or delete source port and destination port entries as follows:
1.Use the arrow keys to highlight the Source Port field.
2.Press the SPACE bar or BACKSPACE one or more times to increment or decrement the port number displayed in the brackets [n] until the appropriate port number displays.
3.Use the arrow keys to highlight the Destination Port field.
4.Use the SPACE bar or BACKSPACE to step to the appropriate port number for the destination port.
5.Use the arrow keys to highlight ADD or DEL (delete) in the Status field.
6.Use the SPACE bar to set Status to either ADD or DEL (delete) and press ENTER. This adds or deletes the port selections made in steps 2 and 4 and also updates the screen Source Port and Destination Port list.
7.Use the arrow keys to highlight ON or OFF in the Errors field.
8.Use the SPACE bar to set Errors to either ON or OFF and press ENTER. ON forces the source port to forward errored frames to the destination port(s). OFF forces the errored frames to be dropped before forwarding traffic.
NOTE |
If more than one port is to be redirected, repeat steps 1 through 8 for each additional setting, then go to step 9 to save all the new settings at once.
9.Use the arrow keys to highlight SAVE at the bottom of the screen. Press ENTER. The message “SAVED OK” displays. This saves the new settings and updates the Source Port and Destination Port
|
