Cabletron Systems 2H23-50R, 2H33-37R manual Setting the Port Operating Mode

Repeater Port Configuration Screen

MODE PORT STAT. (Toggle)

Used to enable (turn on) or disable (turn off) the port. To set the port to operating mode, refer to Section 5.19.2.

SET ALL PORTS (Selectable)

Used to select operating mode for all the ports on the connector simultaneously. This field steps through the following selections: Auto-Neg., 10Base T, and 100Base-TX. To set all networks to the same operating mode, refer to Section 5.19.3.

CONNECTOR # (Selectable)

Selects the front panel connector to which the settings will be applied.

5.19.1 Setting the Port Operating Mode

To set the operating mode for one or more network ports, proceed as follows:

1.Use the arrow keys to highlight the CONNECTOR # field.

2.Use the SPACE bar to step to the appropriate connector number.

3.Use the arrow keys to highlight the MODE DESIRED OPER. field of the network being configured.

4.Use the SPACE bar to step to the appropriate Operating Mode (Auto-Neg, 10Base-T, or 100Base-TX).

5.If setting the operating mode on other ports, repeat steps 3 and 4 for each one and then proceed to step 6.

6.Use the arrow keys to highlight the SAVE command.

7.Press ENTER. The message “SAVED OK” displays and all operating mode settings are saved.

2H23-50R/2H33-37R User’s Guide 5-69