Chapter 5: Local Management

The following introduces each screen that is accessible from the Repeater Configuration Menu.

REPEATER PORT CONFIGURATION

Used to monitor the link status and current operating mode of each port on the 10-Mbps or 100-Mbps network of a front panel connector, and also turn each port on or off. For details, refer to Section 5.19.

DEVICE LEVEL SECURITY CONFIGURATION

Used to set the state of security for each port of a connector. All ports on a connector can be set to receive all frames (NonSecure state), lock on the source address of the next frame received (LockOnNext), or lock on the address of the last frame received (LockedOnAddr). For details, refer to Section 5.20.

PORT LEVEL SECURITY CONFIGURATION

Used to set the security for all ports of a connector. For details, refer to Section 5.21.

5.19REPEATER PORT CONFIGURATION SCREEN

The Repeater Port Configuration screen, Figure 5-26, is used to monitor the link status and current operating mode of each port on a 10-Mbps or 100-Mbps network of a front panel connector. The screen is also used to change the operating mode, and turn each port on (enable) or off (disable).

To access the Repeater Port Configuration screen, use the arrow keys to highlight the REPEATER PORT CONFIGURATION menu item from the Repeater Configuration Menu screen and press ENTER. The Repeater Port Configuration screen displays.

5-66

2H23-50R/2H33-37R User’s Guide

Page 116
Image 116
Cabletron Systems 2H33-37R, 2H23-50R manual Repeater Port Configuration Screen