Cabletron Systems 2H33-37R, 2H23-50R manual Switch Configuration Screen, CONN/Port Organization

Chapter 5: Local Management

5.10SWITCH CONFIGURATION SCREEN

NOTE

The Switch Configuration screen is not available if the operational mode of the device is set to SECURE FAST VLAN. This screen may only be used when the device is configured to operate as an 802.1D or 802.1Q switch.

The Switch Configuration screen, Figure 5-17, provides the basic setup options to make a switch operational in your network.

To access the Switch Configuration screen from the Device Configuration Menu screen, use the arrow keys to highlight the SWITCH CONFIGURATION menu item and press ENTER. The Switch Configuration screen displays up to 8 ports. To view or edit the fields for other ports, highlight NEXT at the bottom of the screen and press

ENTER.

Depending on the optional interfaces installed and if the device is a 2H23-50R or 2H33-37R, there can be 10 or 7 ports, respectively. As shown in Table 5-4, there are two network ports per RJ21 CONN connector.

Table 5-4 CONN/Port Organization

2H23-50R		2H33-37R
CONN 1 = Network Port 1,	10 Mbps	CONN 1 = Network Port 1,	10 Mbps
Network Port 2,	100 Mbps	Network Port 2,	100 Mbps
CONN 2 = Network Port 3,	10 Mbps	CONN 2 = Network Port 3,	10 Mbps
Network Port 4,	100 Mbps	Network Port 4,	100 Mbps
CONN 3 = Network Port 5,	10 Mbps	CONN 3 = Network Port 5,	10 Mbps
Network Port 6,	100 Mbps	Network Port 6,	100 Mbps
CONN 4 = Network Port 7,	10 Mbps	HSIM = Port 7
Network Port 8,	100 Mbps
Fast Ethernet Slot 5 = Port 9
Fast Ethernet Slot 6 = Port 10

5-38 2H23-50R/2H33-37R User’s Guide