Chapter 5: Local Management

module to which the user may wish to restrict access. Section 5.15.10 describes how to set the Management Mode.

Com (Toggle)

This field allows the user to enable or disable the COM port. The selection toggles between ENABLED and DISABLED. The default is ENABLED. For details about setting up the COM port, refer to Section 5.15.11.

Application (Modifiable)

Displays the application set for the COM port. This field allows you to set the application that the COM port will support, which includes:

Local Management (LM) via a terminal or modem connection

Uninterruptible Power Supply (UPS)

The UPS setting allows you to use the COM port to monitor an American Power Conversion Uninterruptible Power Supply (UPS). For UPS, the baud rate is automatically set to 2400.

The baud rate setting for LM is automatically sensed.

For details about how to configure the COM port for various applications, refer to Section 5.15.11.

Clear NVRAM (Toggle)

This allows the user to reset NVRAM to the factory default settings. All user-entered parameters, such as IP address and Community Names are then replaced with DLE2X-MA and DLE3X-MA default configuration settings. For details, refer to Section 5.15.13.

IP Fragmentation (Toggle)

This field allows the user to enable or disable IP fragmentation. The default setting for this field is ENABLED. If the DLE2X-MA or DLE3X-MA will be bridged to an FDDI ring, IP Fragmentation should be enabled. If IP Fragmentation is disabled, all FDDI frames that exceed the maximum Ethernet frame size will be discarded. For details on enabling or disabling IP Fragmentation refer to Section 5.15.14.

5.15.1 Setting the IP Address

To set the IP address, perform the following steps:

5-40 DLE22-MA,DLE32-MA,DLE23-MA and DLE33-MA User’s Guide

Page 104
Image 104
Cabletron Systems DLE33-MA, DLE22-MA, DLE32-MA, DLE23-MA manual To set the IP address, perform the following steps