Cabletron Systems DLE23-MA, DLE33-MA, DLE22-MA manual Telnet Connections, Accessing Local Management

Accessing Local Management

5.3.4Telnet Connections

Once the module or chassis has a valid IP address, the user can establish a Telnet session with Local Management from any TCP/IP based node on the network. Telnet connections to the DLE2X-MA and DLE3X-MA require the community name passwords assigned at the SNMP Community Names screen of either the DLM6C-AA chassis, or the module. For additional information about community names, refer to Section 5.8, SNMP Community Names Screen. Refer to the instructions included with the Telnet application for information about establishing a Telnet session.

5.4ACCESSING LOCAL MANAGEMENT

Access to Local Management is controlled through the Password screen, Figure 5-3. Whenever a connection is made to the DLE2X-MA and DLE3X-MA the Password screen displays. Before continuing, the user must enter a password which is compared to the previously stored passwords. The level of access allowed the user depends on the password. To set or change passwords refer to Section 5.8. The following steps describe the procedure to access Local Management.

1.Turn on the terminal. Press ENTER (this may take up to four times, because the COM port of the DLE2X-MA and DLE3X-MA auto-senses the baud rate of the terminal) until the DLM6C-AA Local Management Password screen, Figure 5-3, displays.

DLE22-MA,DLE32-MA,DLE23-MA and DLE33-MA User’s Guide 5-7