Chapter 3: Installation

3.3DLE2X-MA AND DLE3X-MA OPTIONS

Install any optional equipment before proceeding to

Section 3.4.

If the DLE2X-MA is to be installed with an optional Fast Ethernet Interface Module, refer to Appendix C for installation instructions. The installation instructions for the HSIMs available for the DLE3X-MA are located in the associated user’s guide.

3.4INSTALLING THE DLE2X-MA AND DLE3X-MA INTO THE DLM6C-AA CHASSIS

Failure to observe static safety precautions could cause

!damage to the DLE2X-MA and DLE3X-MA. Follow static safety handling rules and properly wear the antistatic wrist strap

provided with the DLM6C-AA chassis.

Do not cut the non-conductive bag to remove the module.

!Damage could result from sharp objects contacting the board or components.

The DLE2X-MA and DLE3X-MA can be installed in any of the 5 slots that are available. To install a module, proceed as follows:

1.Remove the blank panel covering the slot in which the module will be installed. All other slots must remain covered to ensure proper airflow and cooling. (Save the blank plate in the event you need to remove the module.)

2.Carefully remove the module from the shipping box. (Save the box and packing materials in the event the module must be reshipped.)

3.Locate the antistatic wrist strap shipped with the DLM6C-AA chassis. Attach the strap to your wrist and plug the cable from the antistatic wrist strap into the ESD grounding receptacle at the upper right corner of the DLM6C-AA.

3-2 DLE22-MA, DLE32-MA, DLE23-MA and DLE33-MA User’s Guide

Page 44
Image 44
Cabletron Systems DLE33-MA, DLE22-MA, DLE32-MA, DLE23-MA manual DLE2X-MA and DLE3X-MA Options