Chapter 5: Local Management

Management or UPS applications. Select DISABLED if you wish to disable the COM port for additional module security.

If the COM port is reconfigured without a valid IP address set

!on the module or chassis, the message shown in Figure 5-19 displays. Do not continue unless the outcome of the action is

fully understood.

WARNING

THE COM PORT HAS BEEN RECONFIGURED AND THERE IS NO IP ADDRESS SET FOR THIS DEVICE. YOU WILL NO LONGER BE ABLE TO MANAGE THIS BOARD. DO YOU STILL WISH TO RECONFIGURE THIS COM PORT?

YES

NO

LKG-10849-98F

Figure 5-19 COM Port Warning Screen

If the DLM6C-AA chassis has been configured with a valid IP address this screen will not appear. When the chassis is assigned a valid IP address all the interface modules installed share this same address.

3.Use the arrow keys to highlight YES. Press ENTER.

4.If you ENABLED the port, proceed to Section 5.15.12. If you DISABLED the port, use the arrow keys to highlight SAVE at the bottom of the screen, then press ENTER. When the message “SAVED OK” displays, the edits are saved.

5-48 DLE22-MA,DLE32-MA,DLE23-MA and DLE33-MA User’s Guide

Page 112
Image 112
Cabletron Systems manual 48 DLE22-MA,DLE32-MA,DLE23-MA and DLE33-MA User’s Guide, COM Port Warning Screen