General Config uration Screen
DLE22-MA,DLE32-MA,DLE23-MA and DLE33-MA User’s Guide 5-47
2. Use the SPACE bar to toggle the options (DISTRIBUTED or
STAND ALONE) until the desired mode displays.
3. Use the arrow keys to highlight the SAVE command, then press
ENTER. The warning screen shown in Figure5-18 displays.
4. Use the arrow keys to highlight the YES command and press ENTER.
The changes are saved and the module reboots.
5.15.11 Configuring the COM Port
The DLE2X-MA and DLE3X-MA COM ports support the following
applications:
•Local Management connections
•American Power Conversion Uninterruptible Power Supply (UPS)
connections
To configure the COM port, proceed as follows:
1. Use the arrow keys to highlight the Com field.
2. Press the SPACE bar to choose either ENABLED or DISABLED.
The COM port must be ENABLED if it will be used for Local
!
Before altering the COM port settings, ensure that a valid IP
address is set for the module or chassis. (Refer to
Section5.15.1, Setting the IP Address.) Read this entire
COM port configuration section before changing the settings of
the COM port.
Refer to the Release Notes included with the DLE2X-MA and
DLE3X-MA to verify which COM Port applications are currently
supported.
!
Do NOT disable or alter the settings of the COM port while
operating the current Local Management connection through a
terminal. Altering the COM port settings di sconnects the Local
Management terminal from the port, and e nds the Local
Management session.