
Appendix C: Optional Installations and Mode Switch Bank Settings
C.2 REMOVING THE CHASSIS COVER
This section describes how to remove the
DO NOT REMOVE THE COVER FROM THE
!WHILE POWER IS APPLIED TO THE UNIT.
CAUTION
THIS UNIT MAY HAVE MORE THAN ONE POWER SUPPLY CORD. DISCONNECT ALL POWER SUPPLY CORDS BEFORE SERVICING.
DO NOT POWER UP THE
To remove the chassis cover, proceed as follows:
1.Disconnect the
a.For the
For the
Before performing step b, mark the cables connected to the
TIP
b. Disconnect all network cables attached to the
2.If the
3.Use a Phillips screwdriver to remove the seven screws attaching the cover to the chassis. (See Figure
4.Remove the cover by sliding it back until it clears the front of the chassis and then lifting it straight up and off of the chassis.
To reinstall the chassis cover, perform the removal procedures in reverse.
|