General Configuration Screen

5.7.10 Configuring the COM Port

Upon power up, the COM port is configured to the default settings of ENABLED and LM.

Before altering the COM port settings, ensure that a valid IP

!address is set. Refer to Section 5.7.1. Read this entire COM

CAUTION

port configuration section before altering the COM port

 

 

settings.

The 2M46-04R COM port supports the following applications:

Local Management connections

American Power Conversion Uninterruptible Power Supply (UPS) connections

To configure the COM port, proceed as follows:

1.Use the arrow keys to highlight the Com 1 field.

!

CAUTION

Do NOT disable or alter the settings of the COM port while operating the current Local Management connection through a terminal. Altering the COM port settings disconnects the Local Management terminal from the port, and ends the Local Management session. If the 2M46-04R was previously assigned a valid IP address, reenter Local Management by establishing a Telnet connection to the device. If the device does not have a valid IP address and the COM port has been disabled or the settings changed, reset NVRAM on the

2M46-04R (refer to Appendix C) to reestablish COM port communications.

2.Press the SPACE bar to choose either ENABLED or DISABLED. ENABLED allows the COM port to be connected to the terminal and used for a particular application. DISABLED disables the COM port connection to the terminal.

!

If the COM port is configured without a valid IP address, the

screen shown in Figure 5-11displays.

CAUTION

Do not continue unless the outcome of the action is fully

 

 

understood. If the Warning screen displays, continue on to

 

step 3, otherwise, proceed to step 4.

2M46-04R/2M46-04RDC User’s Guide

5-25

Page 73
Image 73
Cabletron Systems pmn manual 10 Configuring the COM Port