Cabletron Systems pmn manual Setting the Default Gateway, Setting the Tftp Gateway IP Address

General Configuration Screen

4.Use the arrow keys to highlight the SAVE command, then press ENTER. The warning screen shown back in Figure 5-10displays.

5.Use the arrow keys to highlight the YES command and press ENTER. The changes are saved and the device reboots.

5.7.3Setting the Default Gateway

If the SNMP management station is located on a different IP subnet than the 2M46-04R, a default gateway must be specified. When an SNMP Trap is generated, the 2M46-04R sends the trap to the default gateway. To set the default gateway, perform the following steps:

1.Use the arrow keys to highlight the Default Gateway field.

2.Enter the IP address of the default gateway using the DDN format. For example: 134.141.79.121

3.Press ENTER. If the default gateway entered is a valid format, the cursor returns to the beginning of the Default Gateway field. If the entry is not valid, the Event Message Line displays “INVALID DEFAULT GATEWAY OR FORMAT ENTERED”. Local Management does not alter the current value, but it does refresh the Default Gateway field with the previous value.

4.Use the arrow keys to highlight the SAVE command.

5.Press ENTER. The Event Message Line at the top of the screen displays “SAVED OK”.

5.7.4Setting the TFTP Gateway IP Address

If the network TFTP server is located on a different IP subnet than the 2M46-04R, a gateway IP address should be specified. To set the TFTP gateway IP address, perform the following steps:

1.Use the arrow keys to highlight the TFTP Gateway IP Addr field.

2.Enter the IP address of the TFTP gateway using the DDN format. For example: 134.141.80.122

2M46-04R/2M46-04RDC User’s Guide 5-21