Cabletron Systems pmn manual Establishing Community Names

	SNMP Community Names Screen
super-user	This community name gives the user read-write
	access to the 2M46-04R MIB objects and
	allows the user to change all modifiable
	parameters including community names, IP
	addresses, traps, and SNMP objects.

5.8.1Establishing Community Names

The password used to access Local Management at the Password Screen must have super-user access to view and edit the SNMP Community Names screen. Using a password with read-only or read-write access does not allow the user to view or edit the SNMP Community Names screen.

NOTE

Any community name assigned in the SNMP Community Names screen is a password to its corresponding level of access to Local/Remote Management. The community name assigned super-user access is the only one that gives the user complete access to Local/Remote Management.

To establish community names, proceed as follows:

1.Use the arrow keys to highlight the Community Name field adjacent to the selected access level.

2.Enter the password in the field (maximum 31 characters).

3.Press ENTER.

4.Repeat steps 1 through 3 to modify the other community names.

5.Use the arrow keys to highlight SAVE at the bottom of the screen and press ENTER. The message “SAVED OK” displays. The community names are saved to memory and their access modes implemented.

NOTE

Exiting without saving causes a “NOT SAVED?” message to display above the SAVE command. Edits will be lost if they are not saved before exiting.

2M46-04R/2M46-04RDC User’s Guide 5-31