.A.S.U the in Users

Users in the U.S.A.

Users in the U.S.A.

Pre-Installation Requirements for Canon Facsimile EquipmentA.Location

Supply a suitable table, cabinet, or desk. See p. 14-2 for the machine’s weight and dimensions.

B.Order Information

1.Only a single line, touch-tone or rotary telephone set is to be used.

2.Order an RJ11-C modular jack (USOC code), which should be installed by the telephone company. If the RJ11-C jack is not present, installation cannot occur.

3.Order a regular voice grade line or the equivalent from your telephone company’s business representative.

Use one line per machine.

DDD(DIRECT DISTANCE DIAL) LINE

-or-

IDDD (INTERNATIONAL DIRECT DISTANCE DIAL) LINE IF YOU COMMUNICATE OVERSEAS

Canon recommends an individual line following industry standards, e.g. the 2500 (Touch Tone) or 500 (Rotary/ Pulse Dial) telephones. A dedicated extension off a PBX machine without “Call Waiting” can be used with the machine. Key telephone systems are not recommended because they send non-standard signals to individual telephones for ringing and special codes, which may cause a fax error. This machine is not supported on Voice Over Internet Protocol (VOIP).

C.Power Requirements

This equipment should be connected to a standard 120-volt AC, three-wire grounded outlet only. Do not connect this machine to an outlet or power line shared with other appliances that cause “electrical noise.” Air conditioners, electric typewriters, copiers, and machines of this sort generate electrical noise which often interferes with communications equipment and the sending and receiving of documents.

xviii