Error Messages

 

 

 

 

 

Message

Description

Action

 

The memory is full.

– The machine is full of jobs.

– Print, send, or delete any documents

 

 

 

stored in memory.

 

 

 

– Divide the document stack or data into

 

 

 

a few parts and try again one by one.

 

 

 

– Send the document with low

 

 

 

resolution.

 

 

 

– When this message appears during

 

 

 

using the feeder, the scanning

 

 

 

document stops halfway. In this case,

 

 

 

clear the paper jam from the ADF.

 

 

– The number of TX/RX jobs that can

– The maximum numbers of jobs

 

 

be stored in memory reached the

that can be stored in memory are

 

 

maximum.

as follows (Based on the condition

 

 

 

that the other party sends the fax

 

 

 

by the Color imageCLASS MF9170c,

 

 

 

MF9150c and MF8450c with ITU-T No.

 

 

 

1 Chart standard mode); Up to 70 jobs

 

 

 

for sending or 90 jobs for receiving,

 

 

 

95 fax jobs including sending and

 

 

 

receiving, or 75 e-mail and I-fax jobs

 

 

 

for receiving.

 

 

 

Wait for the machine to send any

 

 

 

documents in memory. Also print,

 

 

 

send, or delete any documents stored

 

 

 

in memory.

 

 

 

 

 

The original is too long.

– The originals fed from the feeder

– Reduce the length of the originals

 

 

is longer than 24 7/8" (630 mm), or

to within 24 7/8" (630 mm), then try

 

 

are not feeding correctly.

again.

 

 

– The originals are longer than

– If the originals are shorter than 14"

 

 

14" (355.6 mm) when you are

(355.6 mm), then try the procedure

 

 

sending e-mail, I-fax or sending a

again.

Troubleshooting

 

document to a file server.

 

 

 

 

 

 

 

 

 

 

The scan area is dirty.

The feeder’s scanning area is dirty.

Clean the feeder’s scanning area.

 

 

 

 

 

The TEL number is not registered.

No destination is registered for the

Register the destinations before using

 

 

One-touch you pressed.

the Address Book function.

 

 

 

 

 

This size cannot be used with 2-

The paper size is not appropriate for

Set the paper size to <LTR> or <LGL>,

 

Sided unit modes.

a two-sided copy.

then load paper of the same size.

 

 

 

 

 

Wait a moment...

This message appears when turning

Wait until the message disappears.

 

 

ON the main power switch, or when

 

 

 

 

the machine is not ready for printing.

 

 

 

 

 

 

 

 

12-29