![](/images/new-backgrounds/1110468/110468379x1.webp)
CLI Commands
set
set ipds0
Use the set ipds0 command to setup the DS0 management channel.
Note: the DS0 selected as the DS0 management channel can only reside on the Controller T1.
Syntax: set ipds0 {setting}
Example: set ipds0 assign a:1:24
The example sets the DS0 management channel to slot A, port 1, channel 24.
{setting} |
|
|
assign |
| Assign the DS0 as the IP management channel |
| ||
|
|
|
delete |
| Removes the IP over DS0 management channel [default] |
|
|
|
down |
| Set the DS0 management channel down (disables) [default] |
|
|
|
ip address |
| Set the DS0 management channel’s IP address and optional subnet mask |
|
|
|
navalarm |
| Set reporting of Access Navigator alarm. If IP over DS0 management is |
|
| up and a Navigator is not attached, an alarm will be set. This command |
|
| allows the operator to suppress the alarm in instances when the Axxius is |
|
| not connected to a Navigator. |
|
| Off - Set reporting of Navigator alarm off. |
|
| On - Set reporting of Navigator alarm on. |
|
|
|
up |
| Set the DS0 management channel up (enables) |
|
|
|
[ds0-addrip-addr]
The Controller DS0 addresses are different on the DS3 and DS1 Controller.
DS0 Address on a DS3 Controller in the form
| slot | A for the DS3 Controller card. |
|
|
|
| port | Port number, range or all. |
|
|
|
| ds1 channel | DS1 channel number, range or all. |
|
|
|
| ds0 channel | DS0 channel number, range or all. |
|
|
|
DS0 Address on a DS1 Controller in the form {slot:port:channel} | ||
|
|
|
| slot | A for the DS1 Controller card. |
|
|
|
| port | Port number, range or all. |
|
|
|
Setup the DS0 | management channel IP address and the optional subnet mask, | |
| in the form of xxx.xxx.xxx.xxx, where xxx is between | |
|
|
|
|
|
|
|
|
|
Axxius 800 - Release 2.2 |