![](/images/new-backgrounds/1110468/110468431x1.webp)
CLI Commands
set
set (router) port databits
Use the set (router) port databits command to set the data bits on a TSR port.
Syntax: set
Example: set 5 port 2 databits 6
The example will set the data bits to 6 on the port 2 on the TSR card in slot 5.
{tsr_card-addr}
The slot number
{port-number}
The port number
{5678}
Allowable data bits. Note: If 1.5 Stop Bits is selected, the Data Bits setting MUST be 5
Data Bits, if 2 Stop Bits is selected, 5 Data Bits MUST NOT be selected. See set (router) port stopbits on page
set (router) port dsr low reset
Use the set (router) port dsr low reset command to cause a
Syntax: set
Example: set 5 port 2 dsr low reset enable
{tsr_card-addr}
The slot number
{port-number}
The port number
{disableenable}
disable | Disable will not use the reset feature. Default |
enable | Enable causes the session to teardown when DSR goes low. |
|
|
|
|
|
|
|
|
Axxius 800 - Release 2.2 |