![](/images/new-backgrounds/1110468/110468355x1.webp)
CLI Commands
set
set (ds1)
Use the set (ds1) command to set up DS1 interfaces. The command specifies a range of interfaces and the setting to apply.
Syntax: set
Example: set a:1 framing esf
To set DS1 1 (port 1) on a DS1 Controller to use ESF framing.
{ds1-addr}
The Controller DS1 addresses are different on the DS3 and DS1 Controller, however the DS1 address on the services cards does not change with Controller type (DS3 or DS1). \
DS1 Address on a DS3 Controller in the form {slot:port:channel}
| slot | A for the DS3 Controller card. |
|
|
|
| port | Port number, range or all. |
|
|
|
| ds1 channel | Channel number, range or all. |
|
|
|
DS1 Address on a DS1 Controller or service cards (with DS1 or DS3 controller) in the form {slot:port}
| slot |
| A for the DS1 Controller card, or | |||
|
|
|
|
|
|
|
| port |
| Port number, range or all. | |||
{setting} |
|
|
| |||
ais |
|
| Enable/Disable AIS Forwarding on the DS1. Default is Disabled | |||
| ||||||
|
|
|
| |||
down |
|
| Set the DS1 as | |||
|
|
|
| |||
equipment |
|
| Set equipment loopback on the DS1 | |||
|
|
|
|
|
| |
|
|
|
| loopdown | Disable equipment loopback on the DS1 | |
|
|
|
|
|
| |
|
|
|
| loopup | Enable equipment loopback on the DS1 | |
|
|
|
|
| ||
fdl |
|
| Set the Facilities Data Link (FDL) capabilities | |||
|
|
|
|
|
| |
|
|
|
| none | Disable FDL output messages | |
|
|
|
|
|
| |
|
|
|
| t1403 | Enable T1.403 FDL performance messages | |
|
|
|
|
| ||
framing |
|
| Set the DS1 | framing type to one of the following: | ||
|
|
|
|
|
| |
|
|
|
| d4 | To D4 Superframe (SF) framing | |
|
|
|
|
|
| |
|
|
|
| esf | To Extended Superframe (ESF) framing | |
|
|
|
|
|
|
|
|
|
|
|
|
|
Axxius 800 - Release 2.2 |