Carrier Access Axxius 800 Set router-trunk encapsulation, Set router-trunk multilink group, Ppp

CLI Commands

set

set (router-trunk) encapsulation

Use the set (router-trunk) encapsulation command to specify the encapsulation to use on the TSR interface.

Syntax: set {rtr_trunk-addr} encapsulation {setting}

Example: set 2:1:5 encapsulation pppofr

The example will configure encapsulation on the Router card in slot 2, port 1, trunk 5 to PPP over.

{rtr-trunk-addr}
slot	Slot number (1-8) that contains the Router card
port	Port number of the Router
trunk	Trunk number for this port, 1-24
{setting}
fr		Frame Relay as per RFC 2427
ppp		Point-to-Point Protocol (PPP) as per RFC 1661 and 1662
pppofr		PPP over Frame Relay as per RFC 1973

set (router-trunk) multilink group

Use the set (router-trunk) multilink group command to specify a Router trunk to be part of a multilink PPP group. Note: It is recommended, for performance, that all of the individual links in the multilink group have approximately the same bandwidth.

Syntax: set {rtr-trunk-addr} multilink group {number}

Example: set 3:1:1-2 multilink group 1

The example will form a multilink PPP group that combines trunk 1 and 2.

set 3:1:3 multilink group

The example will add a third trunk to the multilink PPP group from above.

{rtr-trunk-addr}
slot	Slot number (1-8) that contains the Router card
port	Port number of the Router
trunk	Trunk number for this port, 1-24

{number}

The multilink group number. Range is 1-24.

5-150 Axxius 800 - Release 2.2