![](/images/new-backgrounds/1110468/110468425x1.webp)
CLI Commands
set
set (router) ntp poll
Use the set (router) ntp poll command to specify polling of the NTP server every defined
number of seconds. Note: not operational in this release.
Syntax: set
Example: set 1 ntp poll 120
The example will Poll the Network Time Protocol server every 2 minutes, for the Router card in slot 1.
The slot number
{seconds}
The number of seconds between polls. Seconds range is 16 to 1024. Default is 16.
set (router) ntp server
Use the set (router) ntp server command to specify the IP address of the NTP server.
Note: not operational in this release.
Syntax: set
Example: set 1 ntp server 10.10.10.0
The example will set the address to be used to access the NTP server to 10.10.10.0, on the Router in slot 1.
The slot number
{ip-addr}
The IP address of the NTP server, in the form of xxx.xxx.xxx.xxx, where xxx is between
|
|
|
|
Axxius 800 - Release 2.2 |