![](/images/new-backgrounds/1110468/110468327x1.webp)
CLI Commands
Use the print command to display the help information or print the configuration file.
Syntax: print {confighelp}
print config
Print the configuration file for the Axxius 800. The operator may then save this to a text file, which can be sent to another Axxius to automatically configure the system with the original Axxius 800 configuration.
Syntax: print config [rtr_card-addr]
Example: print config 5
This example would produce a configuration file of the Router in slot 5.
Axxius> print config 5 |
|
| ||
set verification off |
|
| ||
password view | {password} | is manual | ||
5 | password config {password} | is manual | ||
5 | password admin | {password} | is manual |
enhanced | security | enable | is manual | |
password | security | {password} is manual | ||
delete 5 remote | "RemoteUnit" |
| ||
set 5 stp enable |
|
|
|
rename 5 "LocalUnit" "LocalAxxius"
set 5:1 ip address 192.168.3.195 255.255.255.0
add 5:1 secondary ip address 192.168.3.194 255.255.255.0 set 5:1 up
set 5:1 collision threshold high 500 add 5 remote "RemoteUnit"
reset 5
Example: print config
This example would produce a configuration file of the Controller.
1.While in a Telnet session to an Adit 600 select Terminal/Start Logging.
2.Name the file.
3.Type the CLI command print config.
4.Select Terminal/Stop Logging.
See Load Controller Configuration on page
|
|
|
|
|
|
Axxius 800 - Release 2.2 |