![](/images/new-backgrounds/1110468/110468353x1.webp)
CLI Commands
set
set(ds0) type
Use the set (ds0) type command to setup one or all DS0s in a DS1 signal type.
Syntax: set
Example: set
To set the traffic type to voice on channels
{ds0-addr}
The Controller DS0 addresses are different on the DS3 and DS1 Controller, however the DS0 address on the service cards does not change with Controller type (DS3 or DS1).
DS0 Address on a DS3 Controller in the form
| slot | A for the DS3 Controller card. |
|
|
|
| port | Port number, range or all. |
|
|
|
| ds1 channel | DS1 channel number, range or all. |
|
|
|
| ds0 channel | DS0 channel number, range or all. |
|
|
|
DS0 Address on a DS1 Controller or service cards (with DS1 or DS3 controller) in the form {slot:port:channel}
| slot | A for the DS1 Controller card, or |
|
|
|
| port | Port number, range or all. |
|
|
|
| channel | Channel number, range or all. |
|
|
|
{datavoice} |
| ||
data |
|
| Set the DS0 up to carry data (clear channel) |
| |||
|
|
|
|
voice |
|
| Set the DS0 up to carry voice traffic |
|
|
|
|
|
|
|
|
Axxius 800 - Release 2.2 |