![](/images/new-backgrounds/1110468/110468981x1.webp)
Maintenance
Software Loading
Loading Router Software via TFTP
1.Login to the Axxius 800, using a terminal emulation program or via Telnet.
2.Enter: load [rtr_card-addr] tftp {ip-addr} "file-name"
The tftp utility provided by Carrier Access with the downloadble software must also be running, in the same directory as the software file.
3.After download, the program will be loaded from RAM into the flash memory and the system will automatically restart. Wait until the boot menu prompt is displayed before powering down the unit. If the download fails and no prompt is seen after a full minute, cycle power and repeat the process.
4.
Command | Description |
|
|
load | CLI command to load software to the Standby |
Controller. See the load tftp command for | |
| details. |
|
|
reset standby | Reset the Standby Controller. You will be asked |
Do you really want to do | to confirm this command, answer Y (Yes). See |
this ? Y | reset (controller) command for details. |
|
|
status equipment | Check the Standby Controller status, when it |
| displays hot standby go on to the next step. If hot |
| standby does not display stop here. If you go |
| further you may affect service. Start the |
| process again and if you are not successful call |
| Customer Service. See status equipment |
| command for more details. |
|
|
switch controller | Set the signal clock switching. See the set clock |
| command for details. |
|
|
You will be disconnected from the unit when switching Controllers.
|
|
|
|
Axxius 800 - Release 2.2 |