Carrier Access Axxius 800 user manual Set ds3

CLI Commands

set

set (ds3)

Use the set (ds3) command to set up DS3 interfaces. The command specifies a range of interfaces and the setting to apply.

Syntax: set {ds3-addr} {setting}

Example: set a:1 framing m23

To set DS3 1 (port 1) on a DS3 Controller (slot A) to use M23 framing.

{ds3-addr}

DS3 address in the form {slot:port}.

	slot	A for the controller card, or 1-8 for service cards.
	port	Port number, range or all.
{setting}
	down	Set the DS3 as Out-of-Service
	up	Set the DS3 as In-Service. Enables alarm reporting (and LED) for the
		port specified
	berthreshold	Set Bit Error Rate protection switchover threshold.
		{value}		4-8 for 10e-4 to 10e-8
	clock	Set the transmit clock source
		loop		Set to clock recovered from the DS3 receive
		normal		Set to master transmit clock source
	dejitter	Turn the De-	jitter buffer on or off
		off		De-jitter buffer off
		on		De-jitter buffer on
	equipment	Set equipment	loopback on the DS3 or PMDL (Path Maintenance Data
		Link) ID
		id		Set the DS3 equipment PMDL ID string
				Command syntax: set {ds3-addr} equipment id
				{"string"}
				{"string"} = transmission vendor’s identification, up to
				30 characters, enclosed in quotes.
		loopdown		Disable equipment loopback on the DS3
		loopup		Enable equipment loopback on the DS3
	facility id	Set the DS3	facility PMDL ID string
		Command syntax: set {ds3-addr} facility id {"string"}
		{"string"} = transmission vendor’s identification, up to 38 characters,
		enclosed in quotes.

Axxius 800 - Release 2.2 5-83