Carrier Access Axxius 800 Set fxsPS or fxsPSM, Set id, FxsPS-addrfxsPSM-addr, Lsrb, Id-name

CLI Commands

set

set (fxsPS or fxsPSM)

Use the set (fxsPS or fxsPSM) command to setup voice channels of an Single Channel POTS card (FXS PS) or the POTS card with modem (FXS PSM). The command specifies the list of voice channels, and the setting to apply.

Syntax: set {fxsPS-addrfxsPSM-addr} {setting}

Example: set 3:1 signal ls

To set the port on slot 3 to Loop Start signaling.

{fxsPS-addrfxsPSM-addr}

Voice channels to apply setting to, in the form of {slot:port}.

	slot	Slot number 1-8, location of the FXS PS or FXS PSM card
	port	Port number or range
{setting}
	rxgain	The receive level range is -12 to +6 (db). Available in .25 dB increments
	signal	Set the DS0 signaling type
		ls	Set to Loop Start signaling
		lsrb	Set to Loop Start signaling with reverse battery
	txgain	Transmit level range is -12 to +6 (db). Available in .25 dB increments

set id

Use the set id command to the unit ID.

Syntax: set id {"id-name"}

Example: set id "Axxius800"

Axxius800>

{"id-name"}

The name must be unique with a maximum of 20 characters. Name must be enclosed in quotes.

5-88 Axxius 800 - Release 2.2