Carrier Access Axxius 800 Set idle, Set ip gateway, Syntax set idle pattern Example set idle 0xff

CLI Commands

set

set idle

Use the set idle command to set the system-wide idle code sent on DS0s.

Syntax: set idle {pattern}

Example: set idle 0xff

{pattern}

A hexadecimal number with a range from 0x00 to 0xff. This number must be preceeded by 0x.

set ip gateway

Use the set ip gateway command to set the IP gateway address (also known as the default route) for the Axxius 800. The command specifies the numeric Internet Protocol (IP) address. The new gateway address will not take effect until Controller is reset (reset command).

Syntax: set ip gateway {ip-addr}

Example: set ip gateway 192.168.100.1

{ip-addr}

Set the IP gateway address for the Axxius 800, using the form xxx.xxx.xxx.xxx, where xxx is a number from 0 to 255.

Axxius 800 - Release 2.2 5-89