Carrier Access Axxius 800 user manual Set, V35-addr

CLI Commands

set

set (v35)

Use the set (v35) command to setup V.35 ports. The command specifies the range of channels within that card, and the setting to apply.

Syntax: set {v35-addr} {setting}

Example: set 6:1 rxclk normal

To set port 1 (v.35) on slot 6 to no inversion on the receive clock

{v35-addr}

In the form of {slot:port}.

slot	Slot number (1-8) of the Axxius chassis where the V.35 card is located
port	Port number or range.

{setting}

Setting to apply one of the following:

clock	Set the clock source to one of the following:
	external	to the external source
	source	to the internal Stratum 4E oscillator
cts	Set the Clear	To Send operation mode to one of the following:
	cd	follow CD
	high	force CTS high
	low	force CTS low
	rts	follow RTS
data	Set the data	mode to one of the following:
	invert	invert the receive and transmit data
	normal	do not invert receive and transmit data
equipment	Sets the V.35	port to equipment loopback, which loops the transmit V.35
	signal back toward the V.35 receive (toward the T1)
	loopdown	disable equipment loopback
	loopup	enable equipment loopback
line	Sets the V.35	port to line loopback, which loops the received V.35 signal
	back toward the V.35 signal toward the V.35 transmit (away from T1)
	loopdown	disable line loopback
	loopup	enable line loopback
rxclkinv	Set the receive	clock invert mode to one of the following:
	invert	invert the receive clock
	normal	do not invert the receive clock

5-170 Axxius 800 - Release 2.2