11For battery-cached SAS/RAID controllers, install the RAID battery. See "Installing a RAID Battery" on page 115.

12Install the expansion card shroud. See "Installing the Expansion Card Shroud" on page 75.

13Close the system. See "Closing the System" on page 70.

14Place the system upright and on its feet on a flat, stable surface.

15Reattach any peripherals, then connect the system to the electrical outlet.

16Turn on the system and attached peripherals.

Removing a SAS Controller Card

1Disconnect the SAS cable, LED cable, and RAID battery cable (if applicable) from the SAS controller card.

2Grasp the card by its top corners and ease it out of its connector. See "Removing an Expansion Card" on page 107.

3If you are removing the card permanently, install a filler bracket in the empty card slot.

NOTE: Filler brackets must be installed over empty expansion card slots to maintain Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system.

4If applicable, remove the RAID battery from the battery holder. See "Installing and Removing a RAID Battery" on page 116.

RAID Battery

The information in this section applies only to systems with the optional battery-cached SAS controller card.

114

Installing System Components

Page 114
Image 114
Dell DR715, T605 owner manual RAID Battery, Removing a SAS Controller Card