Dell T605, DR715 owner manual Removing the Power Supply Distribution Board, 143

7Reattach any peripherals, then connect the system to the electrical outlet.

8Turn on the system and attached peripherals.

Power Supply Distribution Board

If your system has redundant power supplies, it will have a power supply distribution board inside the system.

Removing the Power Supply Distribution Board

1Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.

2Remove the redundant power supplies. See "Removing a Redundant Power Supply" on page 76.

3Open the system. See "Opening the System" on page 68.

4Remove the expansion card shroud. See "Removing the Expansion Card Shroud" on page 72.

5Remove the processor shroud. See "Removing the Processor Shroud" on page 72.

6Remove the power supply distribution board shroud.

Pull the release latch in the direction of the arrow. Holding the latch and the shroud touch point, lift the shroud up and out of the chassis. See Figure 3-38.

Installing System Components

143