Dell T605, DR715 owner manual Installing the Power Supply Distribution Board, 147

bInstall a non-redundant power supply. See "Installing a Non-redundant Power Supply" on page 81.

Figure 3-41. Removing and Installing the Power Supply Cage Cover

3 4

2

1

1	power supply cage cover	2	release pins (2)
3	release pin alignment holes (2)	4	power supply cage

Installing the Power Supply Distribution Board

1If present, remove the power supply cage cover.

Pull the blue release pins until the cover is free from the alignment holes, and lift the cover out of the chassis. See Figure 3-41.

2Position the power supply distribution board so that the securing tabs on the chassis are fully inserted into the securing slots on the board. See Figure 3-40.

Installing System Components

147