Troubleshooting Your System 167
c
Remove the expansion card shroud. See "Removing the Expansion
Card Shroud" on page72.
d
Locate the NVRAM_CLR jumper on your system board (see "System
Board Jumpers and Connectors" on page197) and set the jumper to
the enabled position.
e
Install the expansion card shroud. See "Installing the Expansion Card
Shroud" on page 75.
f
Close the system. See "Closing the System" on page70.
g
Reconnect the system and peripherals to power and restart.
If all USB devices are operational, proceed to the next step.
If the USB devices are still not functioning, see "Getting Help" on
page205.
h
Repeat step a through step c.
i
Set the NVRAM_CLR jumper to the disabled position.
j
Install the expansion card shroud. See "Installing the Expansion Card
Shroud" on page 75.
k
Close the system. See "Closing the System" on page70.
l
Reconnect the system and peripherals to power and restart.
m
Enter the System Setup program and reenter any custom BIOS
settings that were reset. Be sure to leave all USB ports enabled.
Troubleshooting a NIC
Problem
• NIC cannot communicate with network.
Action
1
Run the appropriate online diagnostic test. See "Using Server
Administrator Diagnostics" in "Running the System Diagnostics" on
page194.