Dell T605 Alert! Redundant, Memory disabled, Configuration, Does not support, Redundancy was

CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See your Product Information Guide for complete information about safety precautions, working inside the system, and protecting against electrostatic discharge.

Table 1-6. System Messages

Message	Causes	Corrective Actions
Alert! Redundant	Redundant memory was set	See "General Memory
memory disabled!	to enable in CMOS, but the	Module Installation
Memory	current configuration does	Guidelines" on page 127 for
configuration	not support redundant	memory configuration
does not support	memory.	information. If the problem
redundant		persists, see
memory.		"Troubleshooting System
		Memory" on page 174.

Alert!	A spare rank event occurred
Redundancy was	during the previous boot.
previously lost.
Power cycle
required to
reconfigure
redundant
memory.
Attempting to	Remote Configuration
update Remote	request has been detected
Configuration.	and is being processed.
Please wait...

See "General Memory

Module Installation Guidelines" on page 127 for memory configuration information. If the problem persists, see "Troubleshooting System Memory" on page 174.

Wait until the process is complete.

BIOS Update	Remote BIOS update	Retry the BIOS update. If
Attempt Failed!	attempt failed.	problem persists, see
		"Getting Help" on page 205.

Caution!

NVRAM_CLR jumper is installed on system board.

NVRAM_CLR jumper is installed. CMOS has been cleared.

Remove NVRAM_CLR jumper (see Figure 6-1 for jumper location).

Decreasing	Faulty or improperly installed	See "Troubleshooting System
available memory	memory modules.	Memory" on page 174.

About Your System

33