Dell T605, DR715 owner manual Control Panel Service-only Procedure, Removing the Control Panel, 151

3Reconnect the following cables to the backplane (see Figure 3-42):

•SAS cable

•Power cable

•Backplane cable

4Reseat the hot-plug hard drives in the system. See "Installing a Hot-plug Hard Drive" on page 89.

NOTE: Reinstall the hard drives in the same drive bays from which they were removed.

5Install the processor shroud. See "Installing the Processor Shroud" on page 74.

6Install the expansion card shroud. See "Installing the Expansion Card Shroud" on page 75.

7Close the system. See "Closing the System" on page 70.

8Place the system upright and on its feet on a flat, stable surface.

9Install the front-drive bezel. See "Installing the Front Drive Bezel" on page 66.

10Reattach any peripherals, then connect the system to the electrical outlet.

11Turn on the system and attached peripherals.

Control Panel (Service-only Procedure)

Removing the Control Panel

CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See your Product Information Guide for complete information about safety precautions, working inside the system, and protecting against electrostatic discharge.

1Turn off the system and attached peripherals, and disconnect the system from the electrical outlet and peripherals.

2Remove the front-drive bezel. See "Removing the Front Drive Bezel" on page 66.

3Open the system. See "Opening the System" on page 68.

Installing System Components

151