Dell DR715, T605 owner manual Removing the Front Drive Bezel, Installing the Front Drive Bezel

9	control panel	10	optical disk drive
11	5.25" drive bay	12	3.5" floppy drive
13	front drive bezel	14	expansion card fan
15	3.5" hard drives	16	system board
17	system memory

Front Drive Bezel

The front drive bezel is the cover for the optional optical drive, floppy drive, tape drive, or hot-plug hard drives (when available). To remove or install any of these drives, you must first remove the front drive bezel.

NOTE: If you are removing or installing a hot-plug hard drive (when available), the system may remain turned on and in the upright position when removing the front drive bezel (see "Removing a Hot-plug Hard Drive" on page 88). If you plan to remove or install any other system components, the system should be in the orientation shown in Figure 3-1 (see "Opening the System" on page 68).

Removing the Front Drive Bezel

1Using the system key, unlock the bezel.

2Slide the lever in the direction of the arrow until it releases the bezel from the top of the chassis (see Figure 3-2).

3Rotate the top end of the bezel away from the chassis, and lift the bezel out from the chassis, removing the bezel tabs from the slots as shown in Figure 3-2.

Installing the Front Drive Bezel

1Insert the bezel tabs into the bezel tab slots in the chassis (see Figure 3-2).

2Firmly press the top end of the bezel into the chassis until the lever locks into place.

3Using the system key, lock the bezel.

66

Installing System Components