Table 1-6. System Messages (continued)

Message

Causes

Corrective Actions

 

 

 

Unsupported CPU

Microprocessor(s) is not

Install a supported

combination

supported by the system.

microprocessor or

Unsupported CPU

 

microprocessor combination

 

(see "Processors" on

stepping

 

 

page 133).

detected

 

 

 

Utility

The <F10> key was pressed

Create a utility partition on

partition not

during POST, but no utility

the boot hard drive (see the

available

partition exists on the boot

CDs that came with your

 

hard drive.

system).

Warning: A fatal A fatal system error occurred error has caused and caused the system to

system reset! restart. Please check the system event log!

Warning! No micro Micro code update failed. code update

loaded for processor n

Warning: The

Invalid memory

installed memory

configuration.

configuration is

 

not optimal. For

 

more information

 

on valid memory

 

configurations,

 

please see the

 

system

 

documentation on

 

support.dell.com

 

Check the SEL for information that was logged during the error. See the applicable troubleshooting section in "Troubleshooting Your System" on page 159 for any faulty components specified in the SEL.

Update the BIOS firmware (see "Getting Help" on page 205).

Ensure that the memory modules are installed in a valid configuration (see "General Memory Module Installation Guidelines" on page 127). If the problem persists, see "Troubleshooting System Memory" on page 174.

40

About Your System

Page 40
Image 40
Dell DR715, T605 owner manual Unsupported CPU, Combination, Stepping Detected Utility, Partition not, Installed memory